2jz manual transmission4/5/2024 ![]() The combination meter receives its speed signal from the No.1 speed sensor which is located on the right, rear side of automatic transmission and outputs 4 pulses (0 to Battery Voltage square wave pulses) per sensor shaft revolution. This pin is connected to the combination meter speed output which outputs 4 pulses (Open collector square wave pulses) per No.1 speed sensor shaft revolution. Two speed sensors are used to provide a backup. Vehicle speed is used in idle control, automatic transmission shift control, speed limiting etc. This pin is used to determine vehicle speed. This pin is connected to battery voltage when the ignition switch is in RUN and CRANK positions. The engine ECU is turned on by this signal. This pin is used to determine if the ignition is ON. Note: Blue text indicates terminals related to automatic transmission functions only. JZA80 Toyota Supra 2JZ-GE Engine ECU Pinout JZA80 Toyota Supra 2JZ-GE Engine ECU Part Numbers Toyota Part Number ![]() This page provides information in regards to 2JZ-GE engine wiring as found in the Japanese JZA80 Toyota Supra.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |